We’ve written about how often Vauxhall keys break, they’re the most common key we fix at our shop in Lincoln. Now we’ve found a new type of case that we wanted to tell you about. It’s perfect if you’re looking for a Vauxhall Flip key upgrade.
The new style case has smooth curved lines and hard wearing buttons that won’t perish like the older style cases. Based on the new range of Vauxhall keys, we believe this Vauxhall Flip key upgrade is worth a look.
What do I need for my Vauxhall Flip Key Upgrade ?
Not much, it’s really simple. Firstly you need one of the new style cases. They come in either 2 or 3 buttons, just like the genuine key.
There are only three things that are tricky and we have full instructions below. Here’s a video, plus there are instructions below.
Vauxhall Flip Key upgrade – Stage One – Get the new key cut
Once you have a case, you need to get the blade cut to suit your car. This should be the first job, as you must make sure you have a new key case that turns the locks, before you break open the old key.
Who can cut my key blade?
There are some issues with getting keys cut. Some of the major key cutting chains refuse to cut keys they haven’t supplied. Our local Timpsons stores in Lincoln won’t entertain any key that’s not come from them, and won’t cut the Vauxhall Flip Key upgrade case.
So look for an independent shop, or an Auto Locksmith.
Need to find a good Auto Locksmith? Click here for our advice, wherever you are in the UK.
When we cut eBay or Amazon keys in our shop, we charge £10 and we believe this is reasonable.
Why can’t I swap the key blade on my Vauxhall Flip Key Upgrade?
It’s possible but not straight forward. The key blade is held in to the key body, by a pin. Often, the original key blade from the old case will not fit into the new case. If you want to do this you’ll need to modify the old key blade and this is possible, as the video shows.
However, we think it’s easier just to get the key cut.
Vauxhall Flip Key upgrade – Stage Two – Open the old key.
************* Disclaimer *********
We open up old Vauxhall flip keys all day long at our shop without any problem. However, it’s possible that when the case is opened, the circuit board gets damaged, or the chip fails. When this happens, there’s a chance the car won’t start.
We see Vauxhall flip keys fail even without upgrading or repairing them and have written at length about the problem and the symptoms. So we recommend that you have a spare key, before you decide to carry out your Vauxhall Flip key upgrade.
Ok, back to business. This is really easy if you have a set of Circlip pliers.
These pliers are unusual because the jaws open when you squeeze the handle. They’re perfect to open keys because you can control what you are doing, instead of forcing the case open with a screwdriver etc.
Place the tips of the jaw in the gap by the flip.
Give the handles a squeeze and the case will snap open.
You’ll need to pull the case apart and carefully remove the green circuit board. That’s it! You’ve done the tricky part. Next is a putting together your Vauxhall Flip key upgrade.
Vauxhall Flip Key upgrade – Stage Three – Build the new key.
This may take a few attempts. You may feel you need an extra hand! But just be patient and you’ll manage this no problem. Open the case using the Circlip pliers again. Don’t worry if the key all falls apart, we’re going to show you what to do.
Firstly, put the circuit board into the half of the new case that has the buttons. there are small rubber noggins that locate in the holes. Now put this half of the case down now for a minute.
Fit the pin into the blade holder, (it will only fit one way).
Next the spring needs to go into the blade holder
Locate the plastic spigot in the case and place the spring over it.
Wind the spring counter-clockwise, we recommend two full turns. Then hold the blade shut.
Now put both pieces of the case together, locating the silver pin first and then lining up the two halves.
Once it’s all lined up, give it a squeeze and it should close up nicely. If there is any resistance, it’s because something isn’t lined up. Just open it up again and check it out.
Then when the case is shut, try the flip-out to make sure that your Vauxhall Flip key upgrade has been a success. Then join the case using the two screws.
Lastly, don’t forget the battery.
Just pop off the battery cover and we recommend a fresh, good quality CR2032. Don’t go cheap.
Vauxhall Flip Key upgrade Conclusion
Well done, you should have a new flip key case that looks good and works perfectly!